Sign in Create account

Friendly Ghost Craft

Creating a Friendly Ghost Craft is a spook-tacular way to embrace the Halloween spirit while having a ghoulishly good time. Gather some white fabric or tissue paper, googly eyes, and glue to bring your adorable ghost to life. Cut out the fabric into ghostly shapes, add the googly eyes for a touch of personality, and then hang your spectral creation in a corner of your home for a boo-tiful decoration. Don't forget to give your ghost a warm welcome with a friendly smile, because even the spookiest spirits deserve a little kindness! Happy haunting with your boo-tiful craft!

Supplies

This cute little ghost is made using a foam cone and foam ball covered by a soft white cloth. You could make one in any size you want by using different sizes of foam cones and balls. I used supplies available at Dollar Tree to make this craft simple and inexpensive, so my ghosts are about 9 inches tall. Here’s what you need to make this friendly ghost craft:

  • Foam cone: I used a 7 inch cone from DT
  • Foam ball: I used a 2 inch ball from DT (a slightly larger one would work too!)
  • Microfiber cloth: found in the car care section at DT
  • Small pumpkins: I pulled pumpkins off a floral pick from DT
  • Small square of black felt
  • Small popsicle sticks
  • Fake eyelashes
  • Ribbon

Create The “Body” For Ghost

To begin, break one small popsicle stick in half. These will be used to create “arms” that hold the pumpkin. Push one half of the popsicle stick into the foam cone about 2.5 inches from the top. Push the other half of the popsicle stick into the foam cone far enough away to that the sticks can hold the pumpkin you are using (don’t worry if the pumpkin doesn’t stay in place, you’ll glue it later).

Next, use a little hot glue to adhere the foam ball to the top of the foam cone. Use a small amount of hot glue; using too much can cause the foam to melt.

Create The Ghost

Next, place the white microfiber cloth over the ghosts “body” and arrange it as you like. Then cut out a couple of eyes from black felt and set them on the cloth – they will stick to it without adhesive so you can see if you like the size/shape and placement of the eyes. You can also add a small fake eyelash to each eye.

To make a bow, cut 12 inches of wired ribbon. Fold the ends in toward the middle and overlap them about an inch. Scrunch the ribbon down in the middle, then twist it twice to create a bow shape. (Alternatively you can tie a bow; the twisting method is just super easy if you are using the wired DT ribbon.) Place the bow on the ghost’s head to check the position.

Once you like where everything is, you can use hot glue to secure the eyes, pumpkin, and eyelashes and bow if desired.

Like!
Add to bookmarks
157
No comments