Easy No‑Sew Burlap Ruffle Throw Pillow — Step‑by‑Step DIY
Make a stylish no‑sew throw pillow using a burlap table runner with ruffle trim. This quick project is perfect for beginners and requires only basic supplies: a long runner, hot glue, stuffing, and a few simple tools. The tutorial below shows how to cut, fold, glue, and stuff two 13" x 16" pillows from a 127" table runner.

DIY Easy No Sew Throw Pillow Materials:
Burlap Table Runner with White Ruffles
Glue Gun
Glue Sticks
Polyester Fiberfill or Wool Stuffing
Scissors
Tape Measure
Pencil
DIY Easy No Sew Throw Pillow Instructions:
Lay out your table runner. This is a long table runner at 127″. You can make two pillows out of it – and there will still be burlap to spare that you can hang onto for a future project.

Measure the burlap from the end (from the start of the burlap, not the end of the white ruffle) to 26″ inches.

Draw a line and cut at 26″. Do this 2 times, once on each end of the table runner.

Take one of the cut pieces of burlap and fold it in half. Place the ruffles on your right hand side with the back of the pillow on the top. Your pillow is about 13″ high and 16″ wide. If you want more burlap showing above the ruffles on your pillow, you can make the pillow more square if you desire.

Get your glue gun and match up the two top right corners and glue it together. From there, continue gluing the side. I suggest placing about 2 inches of hot glue on the bottom, securing it, and letting it dry for a few seconds before moving on to the next section. Warning: The glue is HOT! Be careful not to touch the glue gun tip or the glue directly.
You can use the eraser end of a pencil to press the two pieces of burlap together while you wait for the glue to set. When the side is glued together, do the same for the bottom of the pillow (the top of the pillow is where the fold is).
Leave the last side open while you fill your pillow either with polyester fiberfill or wool stuffing. This tutorial is done with wool stuffing. Stuff the no‑sew pillow as full as you’d like it.

Now glue together the last side. You will need to push the polyester fiberfill or wool stuffing out of the way as you apply glue so the stuffing does not get stuck in the seam.
Repeat all steps for the second pillow.

Wait for each pillow to fully cool and dry. Then fluff your pillows and add them to your decor! As the tag on the burlap recommends, spot clean only — do not place this pillow in your washer or dryer.